|
VDSL Switch 8 Ports range up to 1700 m. and Bandwidth up to 25 Mb/s
General Description
The NVF-800S is a VDSL IP DSLAM that aggregates 8 lines of 4-band Very-High-Data-Rate Digital Subscriber Line (VDSL) into Giga Ethernet uplinks for high-speed data/Internet services.
Based on QAM-based 4-band VDSL technologies, NVF-800S extends data service with line rate of solution for services such as remote lecturing, telemedicine, video conferencing, Video-on-Demand (VoD), IP-TV etc. Internet access, and other various high-speed data applications.
When the number of subscribers increases, the second uplink fast Ethernet interface can be used to daisy chain to another NVF-800S. Alternatively, multiple NVF-800S can be connected to another LAN switch to form a two-tier configuration, thus supporting a lot more subscribers. The NVF-800S is an ideal solution for delivering cost-effective, high-performance broadband/multimedia services to Multi-Tenant Units (MTUs) or Multi-Dwelling Units (MDUs) such as hotels, campus, hospitals and telecom.
Key Features & Benefits
· Compliant with IEEE 802.3 & 802.3u Ethernet Standards
· Compliant with ETSI, ITU, ANSI standards
· Supports 5M/15M/25Mbps per port symmetrical bandwidth over phone wiring with long driver capable1.7/1.1/0.6Km(5577/3609/1968 feet).
· Provides 2 x 10/100/1000Mbps Ethernet RJ-45 Ports with Auto MDI/MDIX
· Supports quality of phone wiring detected with SNR(Signal to Noise Ratio) indications
· Supports GARP/GVRP IEEE-802.1p/q VLAN with 256 groups static Vid or 4094 groups dynamic Vid
· Flow control method by IEEE802.3x for Full Duplex & Back Pressure for Half Duplex
· Compliant with IEEE 802.1v protocol-base VLAN classification
· Compliant with IEEE 802.1p
COS
by class of service with 2-level priority queuing
· Compliant with LACP IEEE 802.3ad Trunking
· Supports Auto-speed
· Supports Multicast IP table/IGMP v2 with 512 groups
· Supports LACP IEEE-802.1ad Port Trunking(Link aggregation)
· Supports IEEE 802.1d Spanning trees for MAC bridge with redundant link
· Supports port Mirroring (Sniffer)
· Support Broadcast Storm filtering
· Ethernet transport with POTS / ISDN traffic over single copper wire pair
· Spectral compatibility with XDSL, ISDN(2B1Q/4B3T),HomePNA.
· Supports port security with MAC address filtering & IP limitation.
· Supports Web Base and Telnet for remote management
· Supports system POST LED
· Supports SNMP v1 RFC-1493 Bridge MIBs:RFC-1643 Ethernet MIB, RFC-1213 MIB II, Net-sys Enterprise MIB(Fan and Temperature management)
· Supports RMON groups 1(Statistics), 2(Alarm), 3(Event), 9(History)
· Cascading up to 8 Units along with Giga switch
· Supports TFTP/XMODEM for firmware upgrade
· Supports In-Band/Out-of-Band Management
· Supports Fan & Temperature Monitor & management
· Surge protected for VDSL ports
· Splitter on board
Specifications
· 10/100/1000Mbps Ethernet ports:2 x RJ-45 with auto crossover
· POTS/ISDN splitter port:8 x RJ-45
· VDSL port:8 x RJ-45
· MAC address table:8K Entries
· Switching method:Store-and-forward
· RS-232 console port:DB-9Pin Female / 9600bps
· Port security by MAC address filtering
· LED indication:Power good and POST LED, Link/Active/Speed Status for Ethernet port, Link for VDSL port
· VDSL Frequency Spectrum:Transmitter: 0.9MHz ~ 3.9MHz, Receiver: 4MHz ~ 7.9MHz
· POTS/ISDN pass filter spectrum:0 ~ 630 KHz
· Internal switching power adapter Input: AC 85-265 volts/50-60Hz/1A
· Dimensions: 435 x 255 x 44 mm
· Operating Temperature : 0°C ~ 50°C(41F ~ 122F)
· Storage Temperature : - 20°C ~ 65°C(-4F ~ 149F)
· Humidity: 10%~90% non-condensing
· Safety: FCC, CE Mark
· RoHS compliant
|